Assembly; Plumbing Connections; Drain Connections; Fill Connection - Global-Tek GT-CR1/BU Instruction & Installation Manual

Global-Tek (Singapore) Pte Ltd
After unpacking the dishwasher, remove the items shipped uninstalled (overflow
tube, pump intake strainer, curtains, and chamber hole plug kit) and instruction
manual inside the machine. Set the dishwasher in its proper location. Adjust the
height and level by turning the adjustable feet. NOTE: The dishwasher must be
positioned and leveled before making plumbing connections.

ASSEMBLY

Dish tables should be fitted into the dishwasher. Use Mastic between table and lip of
tank to prevent leakage. Rack track height should be from 4 mm to 6 mm above the
tank lip. Dish tables should be sloped so that any water carried from the dishwasher
will drain back into it.

PLUMBING CONNECTIONS

WARNING: PLUMBING CONNECTIONS MUST COMPLY WITH
APPLICABLE SANITARY, SAFETY, AND PLUMBING CODES.
The plumber who connects this machine is responsible for making certain that both
water and steam lines are THOROUGHLY FLUSHED OUT BEFORE connecting to
any manual valve or solenoid valve.
Manual valves or solenoid valves fouled by foreign matter, and any expenses
resulting from this fouling, are NOT the responsibility of the manufacturer.
DRAIN CONNECTION
Connect the drain through a trap to the sewer pipe.

FILL CONNECTION

2
Use pipe for the connecting line. The flowing pressure is preset 1.4kg/cm . Water
flows into booster and is heated, then into wash tank. After the tank is filled, the
float-controlled high-water switch closes the solenoid valve. If during the operation
water level in wash tank is lower then the required water level, fill solenoid valve
will be opened to top-up the tank.
Page 7