Global-Tek GT-CR1/BU Instruction & Installation Manual page 11

Global-Tek (Singapore) Pte Ltd
5. Remove wash arms. Thoroughly flush the wash arm in a sink and replace the
wash arm end caps(a twisting action helps ensure proper seating).
6. Clean off any scraps from machine walls.
7. Remove all strainer pans and strainer basket(s). Empty contents into garbage can
or disposer and thoroughly clean pans and basket(s).
8. Remove and clean pump intake strainer. Remove final rinse pan strainer. Clean
out pan and drain opening in pan bottom. Clean off strainer.
9. Remove curtains. Thoroughly scrub, rinse, and allow to dry at the end of each
day's operation. See appropriate curtain for proper curtain installation.
10. THOROUGHLY wash out the interior of the machine with a high-pressure hose.
11. Place all strainer pans, strainer basket and pump intake strainer to original
locations.
12. Install upper wash arms. Rest the manifold on the rear hanger bracket with the
open end of the arm next to the wash pipe and rotate the arm upward to latch it.
13. Insert the lower wash arm at an angle between the conveyors and install the
retainer over the pin. Rotate the arm toward the catch and engage the hook into
the notch.
14. Leave door open and curtains removed while machine is not in use. This will
allow the interior to air out and dry.
WARNING: DISCONNECT ELECTRICAL SUPPLY AND PLACE A TAG AT
THE DISCONNECT SWITCH TO INDICATE THAT YOU ARE WORKING ON
THE CIRCUIT BEFORE BEGINNING ANY MAINTENANCE PROCEDURE.
Some machines may have more than one electrical power supply. All supplies
MUST be disconnected.
WARNING: Disconnect Hi-Limit protector circuit when repairing booster. After
service completed, connect Hi-Limit protector until the machine has completely
filled. Failure to follow this procedure can result in damage to booster.
VENT
cool, check the vent (if installed) of this dishwasher every six months for
When
obstructions.
MOTOR LUBRICATION
None required.
MAINTENANCE
Page 11