Start Up The Rackstation - Synology RackStation RS814+ Quick Installation Manual

Remove RAM Module from RackStation
1 Follow steps 1 to 2 of "Install a RAM Module" to remove the circuit board.
2 To remove the RAM module, follow the steps below:
a Release the levers on the memory slot by pushing outwards simultaneously.
b Hold the memory module by the edges and remove it from the slot.
3 Follow step 4 of "Install a RAM Module" to replace the circuit board.

Start up the RackStation

1 Connect one end of each power cord to the power ports located on the back of the RackStation and the other
end to a power outlet.
2 Connect at least one LAN cable to one of the LAN ports and the other end to your switch, router, or hub.
3 Press the power button to turn on your RackStation.
Your RackStation is now online and detectable from a network computer.
11 Chapter 2: Hardware Setup