Start Up Your Rackstation - Synology RackStation RS212 Quick Installation Manual

3 Insert the loaded hard drive tray into the empty hard drive bay.
Important:
Make sure the tray is pushed in all the way. Otherwise, the hard disk might not be able to function
properly.
4 Press the handle in flush with the front panel to hold the hard drive tray in place.
5 Repeat the steps above to assemble the other hard disk you have prepared.
6 Fix the two rack mount kits on both sides with their screws provided.
7 The disks' positions are numbered as shown below.
Note: If you want to set up a RAID set, it is recommended that all installed hard disks are of the same size to make
the best use of hard disk capacity.

Start Up Your RackStation

1 Connect one end of the power cord to the power port of RackStation, and the other to the power outlet.
2 Use the LAN cable to connect RackStation to your switch/router/hub.
3 Press and hold the power button to turn on your RackStation.
Your RackStation is now online and detectable from a network computer.
7 Chapter 2: Hardware Setup