Solectek SkyWay-Excel Series User Manual page 66

252.227-7013 and in subparagraphs (a) through (d) of the Commercial Product-Restricted Rights Clause at
52.227-19. Contractor/Manufacturer is Solectek, 8969 Kenamar Dr, Suite 113, San Diego, CA 92121.
5. Radio Transmission Notice
This product is a low power (less than 1 Watt), OFDM radio system pre-set to transmit and receive signals in the
4.940 – 4.990 GHz or 5.725 – 5.850 GHz frequency bands. This product has been certified by the U.S. Federal
Communications Commission for use in the United States of America in that band. Other markings on the unit
label shall indicate regulatory compliance in other international areas.
Any prospective user of this product outside the United States of America should, prior to such use, contact the
government department or other agency responsible for assigning radio frequencies in the country in which use is
proposed to determine whether such department or agency has any objection to operation of the product given
current regulatory label markings on said product, and whether there are any other local devices generating signals
in that band which might be expected to interfere with the operation of this product.
Solectek shall not be responsible for any operation of this product which is in violation of local law, creates
interference harmful to other local devices, or results in a malfunction of this product caused by outside
interference.
This device must be professionally installed and used in strict accordance with the manufacturer's
instructions. The installer shall be responsible for ensuring that the proper antenna is employed so
that the limits in this part are not exceeded, including the requirements of FCC Part 15.203
However, there is no guarantee that interference to radio communications will not occur in a particular commercial
installation. In case the device does cause harmful interference with an authorized radio service, the user/ operator
shall promptly stop operating the device until harmful interference has been limited. Solectek Corporation is not
responsible for any radio or television interference caused by unauthorized modification of this device or the
substitution or attachment of connecting cables and equipment other than specified by Solectek Corporation. The
correction of interference caused by such unauthorized modification, substitution, or attachment will be the
responsibility of the user.
6. Warning
The antennas used for this transmitter must be installed to provide a separation distance of at least 100 cm from all
persons and must not be co-located or operating in conjunction with any other antenna or transmitter
This device has been designed to operate with the antennas listed below, and having a maximum gain
of 29 dBi. Antennas not included in this list or having a gain greater than 29 dBi are strictly prohibited
for use with this device. The required antenna impedance is 50 ohms.
Pulse RO5810NM 5.8 GHz Omni
•
Pulse R04910NM4.9 GHz Omni
•
ARC Wireless Solutions 4.940-5.875GHz 23dBi/20dBi Dual Polarization Panel Antenna
•
Laird/ARC HD Series High Performance Dish Antenna HDDA5W-29-DP - 29dBi dual polarity (H
•
and V)
The use of the last two Antennas above shall be restricted to Point-to-Point use only.
66