Technical Specifications; Safety Instructions - Veria Control B35 Installation Manual

1.1 Technical Specifications

Cable specification max.
Ball pressure temperature
Pollution degree
Type
Storage temperature
Protection class
The product complies with the EN/IEC Standard "Automatic
electrical controls for household and similar use":
• EN/IEC 60730-1 (general)
• EN/IEC 60730-2-9 (thermostat)
Produced for:
Veria ApS
Ulvehavevej 44
DK-7100 Vejle
Denmark
Fax: +45 7488 7151
E-mail: mail@veria.dk
1x4mm² or 2x2,5mm²
75°C
2 (domestic use)
1C
-20 to +65°C
Class II -
- 4 -

1.2 Safety Instructions

1. Safety Instructions
Make sure the mains supply to the thermostat is turned off
before installation.
IMPORTANT:
When the thermostat is used to control a floor heating
element in connection with a wooden floor or similar material,
always use a floor sensor and never set the maximum floor
temperature to more than 35°C.
Please also note the following:
• The installation of the thermostat must be done by
an authorized and qualified installer according to local
regulations.
• The thermostat must be connected to a power supply
via an all-pole disconnection switch.
• The sensor is to be considered as live voltage. Have this
in mind if the sensor must be extended.
• Always connect the thermostat to continuous power
supply.
• Do not expose the thermostat to moisture, water, dust,
and excessive heat.
- 5 -