Table of Contents
Advertisement
3.Move the lever throttle control to the fast
position.
See the figure.
4. Firmly hold the handle of the starter rope,
pull the starter cord slowly until resistance is
felt, then pull rapidly.
5
If the engine does not start, repeat again
.
the previous three steps until engine fires.
6. Once the engine starts to run, quickly turn
the throttle lever (choke) to the RUN
position.
7. If for some reason the rotor stops spinning,
the engine loses power but it doesn not shut
down, is because this chipper is equipped
with a centrifugal clutch that only engages
when it passes a certain amount of RPMs.
Turn off the engine (as directed below) and
check what is blocking the rotor.
Stopping your engine
1. Move the throttle lever to the start
position, where it was in the beginning (slow
position).
2. Shut the fuel valve and turn the engine
switch OFF.
MAINTENANCE
General recommendations :
1. Always observe safety rules when
performing maintenance.
2. The warranty on this wood chipper, does
not cover items that have been subjected
to wear, misuse or negligence of the
operator. To receive any warranty benefits;
the operator must have maintained the
equipment as indicated in this manual.
13
Advertisement
Table of Contents
