Table of Contents
Advertisement
Discharge Assembly
1.Locate discharge neck as shown in the
figure and secure it to the chipper.
2.Make sure the carriage bolts are placed
inside out so the head is inside the
discharge.
Nuts and bolts:
a. 2 Carriage Bolts 3/8 "x 1"
b. 2 Pressure Washers 3/8 "
c. 2 Hex nuts 3/8 "
Pull Holder Assembly
1. Set pull holder as shown in Fig.
2. Secure in place using carriage bolt.
Nuts and bolts:
a. 1 Carriage Bolt 1/4 "x 1"
b. 1 Pressure washer 1/4 "
c. 1 Hex nut 1/4 "
Setting up your Wood Chipper
Fuel & Oil
Read and follow all instructions in the engine
manual for more information on this matter.
Once you have finished assembling your
wood chipper, you must prepare your
engine for the first start. Locate the fuel cap
in the top of the engine and remove it. You
should
fill
the
approximately 2.5 liters of clean, fresh fuel.
tank
engine
with
10
Advertisement
Table of Contents
