Related Manuals for Sunbeam SNM1501RAW
Summary of Contents for Sunbeam SNM1501RAW
-
Page 1: Installation Instructions
Installation Instructions Over-the-Range Microwaves Models: SNM1501RAW SNM1501RAB SNM1501RAQ SNM1502RAS PTT072506... -
Page 2: Mounting Space
Notes: • Please read all instructions thoroughly before installing the microwave. • Two people are recommended to install this product. • If a new electrical outlet is required, its installation should be finished by a qualified electrician before the microwave is installed. 1. -
Page 3: Electrical Grounding Instructions
3. ELECTRICAL GROUNDING INSTRUCTIONS • This appliance must be grounded. This microwave is equipped with a cord having a grounding wire with a Plug grounding plug. It must be plugged into a wall receptacle 插头 that is properly installed and grounded. In the event of an electrical short circuit, grounding reduces risk of electric shock by providing an escape wire for the electric current. -
Page 4: Tools Recommended For Installation
5. TOOLS RECOMMENDED FOR INSTALLATION • Phillips screwdriver • Electric drill • 1/2”, 5/8” and 3/32” Drill bits • 1-1/2” Wood bit or metal hole cutter (if metal cabinet is used) • Saw to cut exhaust opening (if needed) • Protective drop cloth for product and range –... - Page 5 7. PREPARATION OF THE MICROWAVE • Open the bottom of the carton, remove microwave, all packing materials, Installation Instructions, Wall Template, Top Template and Charcoal Filter; however, DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the ceiling in the microwave cavity. •...
-
Page 6: Ventilation System
8. VENTILATION SYSTEM This microwave is designed for adaptation to three types of hood ventilation systems. Select the type required for your installation. A. Recirculating non-vented, ductless. Follow installation procedure A. a. Recirculating requires the use of the Charcoal Filter 11. b. - Page 7 (B) HORIZONTAL EXHAUST: Outside Ventilation 1. Remove and save 2 screws from back edge and 1 screw from the top center of Fan Cover Bracket. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover Bracket, as shown in Figure 10.
- Page 8 9. MOUNTING MICROWAVE TO WALL at t ached 1. past e on t he cabi net w al l , t he t op shoul d be as appr oachi ng 1. 8m at l east f r om f i gur e 1 t he base of t he cabi net as possi bl e and t o be kept i n t he m i ddl e gr ound t he t op shoul d be 1.
- Page 9 © 2006 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved. Sunbeam ® is a registered trademark of Sunbeam Products, Inc. used under license. Distributed by Petters Consumer Brands, LLC. 4400 Baker Road, Minnetonka, MN 55343. For service, support and warranty information, visit www.sunbeammajorappliances.com or in the US call 1-866-866-6283.