Table of Contents
Advertisement
(B) HORIZONTAL EXHAUST: Outside Ventilation
1. Remove and save 2 screws from back edge and 1 screw from the top center of Fan Cover Bracket.
Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover
Bracket, as shown in Figure 10.
2. Withdraw Hood Fan Unit carefully along with the lead wire out of the outer case.
3. Rotate the Hood Fan Unit and turn end-over-end so that the fan blade openings are facing the
back of the microwave. Replace Hood Fan Unit into the microwave. Be carefully not to pinch the
lead wire between the inner bracket and the Hood Fan Unit. See Figure 11.
4. Put the lead wire into the outer case.
5. Replace the Fan Cover Bracket by sliding it into the slits in the same direction as the arrow on the
Fan Cover Bracket. Make sure the fan blades are visible through the rear openings in the
microwave before proceeding. See Figure 12. Attach Fan Cover Bracket to unit with 3 screws,
which were removed in Step 1 above. See Figure 13. The Hood Fan Unit is now rotated for
horizontal exhaust operation.
6. Attach the Exhaust Damper Assembly to the back of the Mounting Plate by sliding it into the slits
in the same direction as the arrow. See Figure 12. Using Tapping screw 4×12 from the
INSTALLATION HARDWARE, tighten into place.
f i g. 9
Fig. 11
(C) VERTICAL EXHAUST: Outside Ventilation
1. Remove and save 2 screws from back edge and 1 screw from the top center of the Fan Cover
Bracket. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan
Cover Bracket as shown in Figure 10 on page 5.
2. Withdraw Hood Fan Unit carefully and slip wires out of Wire Box. CAUTION: Do not pull or
stretch hood fan wiring.
3. Turn the Hood Fan Unit end-over-end. Rotate the Hood Fan Unit 90 degrees so that the fan blade
openings are facing upward. Figure 12
4. Replace the Fan Cover Bracket by sliding it into the slits in the same direction as the arrow on the
Fan Cover Bracket. Make sure the fan blades are visible through the top openings in the
microwave before proceeding. Attach the Fan Cover Bracket to unit with 3 screws, which were
removed in Step 1 above. See Figure 13. The Hood Fan Unit is now rotated for vertical exhaust
operation.
5. Attach the Exhaust Damper Assembly to the fan cover on the top
of the outer case cabinet after mounting the microwave.
Fig. 13
f i g. 11
l e a d w i r e
7
f i g. 10
Fig. 12
Fig. 14
f i g. 12
Advertisement
Table of Contents
