Ramsey Medical statMAP Instructions Manual page 15

Page 15
CONTROLS AND INDICATORS (con't)
Power/Status Indicator: This LED indicator illuminates
GREEN to inform the user Power is ON.
Status Indicators: At the end of a determination, the LEDs
in the status ovals will flash AMBR and the automatic valve
will open releasing pressure in the cuff. The user must
purge the cuff by squeezing and holding the deflate trigger
until all air is released from the cuff. At that time, the LEDs
will stop flashing and the GREEN Power ON LED will re-
main illuminated, indicating that the statMAP is ready for
use. During an automatic determination, the measuring
LED will illuminate green indicating a measurement is in
progress.
Low Battery Indicator: The low battery indicator may
illuminate during a determination. This is a warning for
battery replacement. When the light remains illuminated,
battery replacement is required. Always replace both AAA
batteries at the same time to ensure proper performance.
Observe the proper orientation of the batteries, since the
unit will not function, and may potentially be damaged, if
the batteries are not inserted properly.
Zero Indicator: The zero indicator is used to verify the
gauge needle accuracy. When the cuff is completely
deflated, the gauge needle should be over the Zero
Indicator. If it is not, open the deflate trigger (see pg. 16)
to release any pressure that remains inside the cuff.