Intex 18'x10 (549cm x 305cm) Owner's Manual page 10

3. Be sure the liner is opened and spread out to its fullest extent on top of the ground cloth.
Starting with one side, slide the closed end of "A" beam first into the sleeve openings
located near the corner. Continue with "B" beam snapping into the "A" beam, and another
"C" beam snapping into the "B" beam.
Keep the metal beam holes aligned with the white liner sleeve holes.
Continue inserting all "A-B-C" beams into the sleeve openings, and do the same on the
other side.
The combinations for beams are different for different sizes of pools, see the chart below
for detail. (Be sure all sides end up with the metal beam holes aligned with the white liner
sleeve holes.)
Size of Pool
18' x10' (549 cm x 305 cm) & 20' x 12' (610 cm x 366 cm)
24' x 12' (732 cm x 366 cm)
28' x 12' (853 cm x 366 cm)
4. Slide the restrainer strap (9) onto the large U-shaped
side support (12). Repeat for all restrainer straps and
U-supports (see drawing 3).
IMPORTANT: The liner is to remain flat on the
ground during the next step #5. This is why 5 - 6'
of clearance space around the pool is necessary.
5. • The tops of the U-shaped side supports have a
double button spring loaded clip that is factory
pre-installed. Insert the side supports into the "A-B-C"
beam holes by squeezing the bottom button inward
with your fingers.
• Squeezing this bottom button will allow the support to
enter the beam. Once the U-support is inside the
beam release the finger pressure allowing the
support to "SNAP" into place. Repeat this procedure
for all U-shaped side supports (see drawing 4).
6. Insert the connecting rods into the overlapping
openings, to connect the liner straps to the
restrainer straps (see drawing 5).
SAVE THESE INSTRUCTIONS
POOL SETUP (continued)
No. of "U-shape" Leg on a side
(88IO) OVAL FRAME POOL ENGLISH 7.5" X 10.3" PANTONE 295U
Beam Combinations
2 A-C
A-B-C
3
4 A-B-B-C
10
11
9
12
9
11
8
11/17/2010
English
88IO
3
4
12
5
Page 10