Intex 18'x10 (549cm x 305cm) Owner's Manual page 12

10. Before filling with water, be sure:
• All the U-shaped side supports (12) are straight and properly aligned;
• All the restrainer straps (9) are positioned in the center of U-shaped side
supports (12);
• The liner straps are pulled outwards from the pool bottom, and the restrainer straps (9)
are taut or laying flat on the ground;
• The drain plug inside the pool is closed and the drain cap on the outside is screwed on
tightly;
Fill the pool with no more than 1 inch of water; and look to see if there is any noticeable
difference in the slope of the pool floor.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely
level. Setting up the pool on unlevel ground will cause the pool to tilt resulting in
the sidewall material to bulge. If the pool is not completely level, you must drain
the pool, level the area and re-fill the pool.
• Begin to smooth out the remainder of wrinkles (from inside pool) by pushing out where
the pool floor and pool sides meet, or (from outside pool) reach under the pool side,
grasp the pool floor and pull out. If the ground cloth is causing the wrinkles, have 2
persons pull from either side to remove all wrinkles.
11. Pool liner walls will rise while filling with water, water may be filled to the bottom of the
inflated ring.
IMPORTANT: As the pool fills with water, check on the U-shaped side supports (12)
to ensure they are straight and properly aligned with the horizontal top beams
periodically until the pool is full of water.
Before allowing anyone to use the pool, hold a family meeting. Establish a set of
rules that include, at a minimum, the important safety rules and general
aquatic safety information in this manual. Review these rules on a regular basis
and with all users of the pool, including guests.
SAVE THESE INSTRUCTIONS
(88IO) OVAL FRAME POOL ENGLISH 7.5" X 10.3" PANTONE 295U
POOL SETUP (continued)
IMPORTANT
11/17/2010
English
88IO
Page 12