Pool Draining - Intex 18'x10 (549cm x 305cm) Owner's Manual

POOL MAINTENANCE & DRAINAGE
CAUTION
Do not add chemicals if the pool is occupied. This can cause skin or eye irritation.
Concentrated chlorine solutions can damage the pool liner. In no event is Intex Recreation
Corp., Intex Development Co. Ltd., their related companies, authorized agents and service
centers, retailers or employees liable to the buyer or any other party for costs associated
with the loss of pool water, chemicals or water damage. Keep spare filter cartridges on
hand. Replace cartridges every two weeks. We recommend the use of a Krystal Clear™
Intex Filter Pump with all of our above-ground-pools.
EXCESSIVE RAIN: To avoid damage to the pool
water that causes the water level to be higher than the maximum.
How to Drain Your Pool and Long Term Storage
Note: This pool has drain valves installed in 2 corners. Connect the garden hose to the
corner valve that directs the water to the appropriate location.
1. Check local regulations for specific directions regarding disposal of swimming pool water.
2. Check to make sure that the drain plug inside the pool is plugged in place.
3. Remove the cap from the drain valve on the outside pool wall.
4. Attach the female end of the garden hose to
5. Place the other end of the hose in an area where the water can be safely drained away
from the house and other nearby
6. Attach the drain connector to the drain valve. NOTE: The drain connector will push the
drain plug open inside the pool and water will start to drain immediately.
7. When the water stops draining, start lifting the pool from the side opposite the drain,
leading any remaining water to the drain and emptying the pool completely.
8. Disconnect hose and adapter when finished.
9. Re-insert drain plug in drain valve on inside of pool for storage.
10. Replace drain cap on outside of pool.
11. Reverse the set up instructions to disassemble the pool. Completely deflate the top ring,
and remove all connecting
12. Be sure that the pool and all parts are completely dry before storage.
the sun for an hour
prevent the vinyl from sticking together and to absorb any
13. Create rectangular shape. Starting at one side, fold one-sixth of liner
Do the same on the opposite side (see drawings 9.1 & 9.2).
14. Once you have created two opposing folded sides, simply fold one over the other like
closing a book (see drawings 10.1 & 10.2).
15. Fold the two long ends to the middle (see drawing 11).
16. Fold one over the other like closing a book and finally compact the liner (see
drawing 12).
17. Store the liner and accessories in a dry, temperature controlled, between 32 degrees
Fahrenheit (0 degrees Celsius) and 104 degrees Fahrenheit (40 degrees Celsius),
storage location.
18. The original packing can be used for storage.
8
10.1
SAVE THESE INSTRUCTIONS
ALWAYS FOLLOW THE CHEMICAL MANUFACTURER'S
DIRECTIONS, AND THE HEALTH AND HAZARD WARNINGS.
and over filling,
the drain
structures.
parts.
before folding (see drawing 8). Sprinkle some talcum powder to
9.1
10.2
(88IO) OVAL FRAME POOL ENGLISH 7.5" X 10.3" PANTONE 295U
immediately drain rain
connector.
Air dry the liner
residual moisture.
into itself twice.
9.2
11
11/17/2010
English
88IO
in
12
Page 14