Pool Maintenance And Chemicals; Common Pool Problems; Troubleshooting - Intex 18'x10 (549cm x 305cm) Owner's Manual

POOL MAINTENANCE & CHEMICALS
REMEMBER TO
• Protect all pool occupants from possible water-related illnesses by keeping the
pool water clean
good hygiene.
• Keep your pool clean and clear. The pool floor must be visible at all times from
the outside barrier of the pool.
• Keep children away from pool covers to avoid entanglement, drowning, or other
serious injury.
Water maintenance
The maintenance of a proper water balance
single most important factor in maximizing the life and appearance of the liner as well
as ensuring clean, healthy and safe water. Proper technique is important for
treating the pool water. See your pool professional for chemical, test kits and testing
procedures. Be sure to read and follow the written instructions from the chemical
manufacturer.
1. Never let chlorine come in contact with the liner if it is not completely dissolved. Dissolve
granular or tablet chlorine first in a bucket of water, then add it to the pool water. Likewise
with liquid chlorine; mix it immediately and thoroughly with the pool water.
2. Never mix chemicals together. Add the chemicals to the pool water separately. Thoroughly
dissolve each chemical before adding another one to the water.
3. An Intex pool skimmer and an Intex pool vacuum are available to assist in maintaining
clean pool water. See your pool dealer for these pool accessories.
4. Do not use a pressure washer to clean the pool.
PROBLEM
ALGAE • Greenish water.
• Green or black spots
• Pool liner is slippery
COLORED • Water turns blue,
WATER
FLOATING • Water is cloudy or
MATTER IN
WATER
CHRONIC LOW • Level is lower than
WATER LEVEL
SEDIMENT ON • Dirt or sand on pool
POOL BOTTOM
SURFACE DEBRIS • Leaves, insects etc.
SAVE THESE INSTRUCTIONS
WARNING
and sanitized. Do not swallow the pool water. Always practice
through appropriate use of sanitizers

TROUBLESHOOTING

DESCRIPTION
• Chlorine and pH level
need adjustment.
on pool liner.
and/or has a bad odor.
• Copper, iron or
brown, or black when manganese in water
first treated with being oxidized by the
chlorine. added
• "Hard water" caused by a
milky. too high pH level.
• Chlorine content is low.
• Foreign matter in water.
• Rip or hole in pool liner
on previous day. or hoses.
• Heavy use, getting in
floor. and out of pool.
• Pool too close to trees.
(88IO) OVAL FRAME POOL ENGLISH 7.5" X 10.3" PANTONE 295U
CAUSE SOLUTION
• Super chlorinate with shock
treatment. Correct pH to your
pool store's recommended level.
• Vacuum pool bottom.
• Maintain proper chlorine level.
• Adjust pH to recommended
level.
• Run filter until water is clear.
chlorine. • Replace cartridge frequently.
• Correct the pH level. Check with
your pool dealer for advice.
• Check for proper chlorine level.
• Clean or replace your filter
cartridge.
• Repair with patch kit.
• Finger tighten all caps.
• Replace the hoses.
• Use Intex pool vacuum to
clean bottom of pool.
• Use Intex pool skimmer.
English
88IO
is the
testing and
Page 13
11/17/2010