Security Menu - ECS Q87H3-M6 User Manual

Security Menu

This page enables you to set setup administrator and password.
Main Advanced
Supervisor Password :
User Password
Change Supervisor Password
TPM Support
TPM State
TPM Operation
Current TPM Status
TPM Enabled Status
TPM Active Status
TPM Owner Status
Removable Device Boot
Chassis Opened Warning
Chassis Opened
ME Enable
Version 2.15.1236. Copyright (C) 2002-2013 American Megatrends, Inc.
Supervisor Password (Not Installed)
This item indicates whether a supervisor password has been set. If the password
has been installed, Installed displays. If not, Not Installed displays.
User Password (Not Installed)
This item indicates whether a user password has been set. If the password has been
installed, Installed displays. If not, Not Installed displays.
Change Supervisor Password (Press Enter)
You can select this option and press <Enter> to access the sub menu. You can use the
sub menu to change the supervisor password.
TPM Support (Enabled)
This item is set to support TPM (Trusted Platform Module) funtion.
TPM State (Disabled)
This item displays the TPM status to be enabled/disabled.
TPM Operation (None)
This item shows the information of the TPM operation.
TPM Enabled Status (Disabled)
This item displays the TPM status to be enable/disable.
TPM Active Status (Activated)
This item displays the TPM status to be active or not.
TPM Owner Status (UnOwned)
This item displays the TPM to be owned or not.
Removable Device Boot (Enabled)
This item enables or disables support the boot from USB mass storage devices.
42
BIOS Setup Utility
Power Authentication
Not Installed
: Not Installed
[Press Enter]
[Enabled]
[Disabled]
[None]
[Disabled]
[Activated]
[Owned]
[Enabled ]
[Disabled]
Yes
[Enabled]
Q87H3-M6 USER MANUAL
Security Boot Options Exit
Valid Keys:
(1)a-z (A-Z) non case sensitive
(2)0, 1-9
(3)11 special keys:'-=[]\;',./
(4)key pad: 0-9 support and
/*-+.(5 special keys)
(5)Only support scan code
:Move
Enter : Select
+/-/Spacebar : Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save and Exit
ESC: Discard changes and Exit
Setup