Initial Set-Up Of Your Oven; Setting The Time Of Day; Before First Use - Venini VEOP610SS User Manual

Initial set-up of your

Setting the time of day

When the oven is connected to your mains
o
(or after a power cut), the digits on the LED display (7) will show
"0:00" and there will be an audible signal.
o Press the clock button (3) and the hour digits will flash on the LED
display.
Turn the adjustmen
o
has a 24 hour clock, so it is possible to adjust the hour digit
between 0 and 23.
o When the correct hour time appears on the LED display, press the
clock button again. The minute digits will flash on the LED display.
o Turn the adjustment knob to adjust the minute time; it is possible
to adjust the minute digit between 0 and 59.
o When the correct minute time appears on the LED display, press
the clock button for a third time to confirm the time of day.
The ":" symbol between the digits will flash and the time of day wil
o
light on the LED display.
IMPORTANT: You
following the instructions above, as lon
currently in u se.

Before first use

o To remove any residue from the oven that may have been left from
the manu facturing process, you should select the convection & fan
oven function and set the thermostat to its maximum temperature
setting.
o It is perfectly normal for a smell to be produced during this process.
o You should make sure that any windows in the room are left open
during this process.
o It is advisable for you not to remain in the room whilst the burning
off process is taking place.
o You should leave the oven on maximum setting for 30 – 40
minutes.
o After the oven cavity ha
warm soapy water, using either a sponge or soft cloth. No abrasive
cleaners should be used.
oven
t knob (6) to adjust the hour time. Your oven
can adjust the time of day at any time by
s cooled, it should then be cleaned with
supply for the first time
g as the oven is not
l
11