To View Or Change The Setpoint; To View The Display Units; Controller Parameters - Thermo Scientific FD1530M Installation And Operation Manual

S S M OTP
INGLE ETPOINT ODEL W/
To Change the Setpoint
If you want to change the setpoint, press the SCROLL
button until "SP1" is displayed. Press the UP or
DOWN button until the desired setpoint value is
displayed and then release the button. A few seconds
after the button is released, the controller will accept
the new value and is indicated by a brief flash of the
display. Press PAGE button to return to HOME
DISPLAY.

To View the Display Units

Press SCROLL until "UNITS" is displayed. The
temperature units are also shown on the HOME
DISPLAY to the right of the measured value (process
value).
Temperature units can be changed by pressing up and
down buttons. Choice of Celsius (°C), Fahrenheit (°F),
Kelvin (°K), Percentage (%), or None (nonE).

Controller Parameters

Home display
°C, °F, °K, %, or None: Temperature units in Celsius
(default), Fahrenheit, Kelvin, Percentage (PErc), or
None (nonE).
A1.DHI: Deviation high alarm.
A2.HI: High Limit alarm. Read Only.
A3.LO: Low Limit alarm. Read Only.
A.TUNE (tune): One-shot autotune enable.
WRK.OP: Working Output power. Read Only.
PV.OFS: Process Value Offset. Read Only.
SP.RAT: Ramp Rate Setpoint (default units is
minutes).
DWELL: Time for dwell or delay (default units is
minutes).
T.STAT: Timer Status. Active only when timer is
active.
TM.CFG: Timer configuration.
13