Table of Contents
Advertisement
LT-800 Quick Reference
LT-800 Front Panel: Controls & Displays
Adjust audio input levels
of Input 1 and Input 2
here. See page 11 for
more information.
Power
ON / OFF
Test Tone: Activates
a tone to aid system
setup.
LT-800 Back Panel: Connections & Settings
Remote Antenna Connection:
See page 19 or the Listen
website for details on antennas
that can be attached here.
Set RF Power level here
(¼, ½, and Full). See
page 8 for guidelines
on setting power levels.
6
Indicates audio input
level of Input 1 and
Shows
Input 2.
mixed audio
level.
Mix Level: Adjust so
the Mix Level meter
occasionally lights
Contour: Equalization
the red LED.
adjustment. Turn
counter-clockwise for
voice and clockwise for
music.
Mix Output: These connectors
contain a mix of Input 1 and
Input 2. They are unbalanced
phono connectors; and the
output level is -10 dBu.
12 VDC 1.3 A
Input 2: Connect
unbalanced audio to these
The Listen LA-207
phono connectors, input
power supply
level -10 dBu or +10 dBu.
connects here.
Indicates
Process Mode
is active.
Indicates
Super Quiet
mode is active.
Channel Select Up:
Press for 3 seconds
to lock on current
channel.
Input 2: Set switch to
match the level of your
Input 2 audio source,
not used to increase or
decrease level by +10 dBu.
Top mount antenna connection:
Remove rubber plug and screw
antenna in place.
LCD: Shows
Monitor Port: Plug
which channel
in a headset and
is selected.
adjust volume.
Channel Select Down:
Press for 8 seconds to
enter program mode.
See page 8 for more
information.
Input 1: Used for balanced
connection of a microphone
or line level input. This
combination connector
accepts either XLR or ¼"
phono plugs.
Select Line, Mic or Mic+Phantom
Power. Line is balanced 0 dBu
input level, Mic is -55 dBu,
+12 VDC supplied in PH Power
position. If not using input 1, leave
in line position.
Advertisement
Table of Contents
