Quick Reference - Listen LT-800 User Manual

Quick Reference

LT-800 Front Panel: Controls & Displays
Adjust audio input levels of
INPUT 1 and INPUT 2 here.
See page 6 for more
information.
Power
TEST TONE: Activates a
ON / OFF
tone to aid system setup
(cannot be heard on
monitor jack)
LT-800 Back Panel: Connections and Settings
REMOTE ANTENNA
CONNECTION: See the Listen
website for details on antennas
that can be attached here.
Set RF Power level here (¼, ½ and
Full). See page 5 for guidelines on
setting power levels.
4
Top antenna connection: Remove
rubber plug and screw antenna in
place.
Indicates audio input
level of INPUT 1 and
INPUT 2
Shows MIX
Audio level
MIX LEVEL: Adjust so the
Mix Level meter occasionally
lights the RED LED
AUDIO OUTPUT: This
connector contains a mix of
INPUT 1 and INPUT 2. This is an
unbalanced phono connector;
the output level is -10dBu.
INPUT 2: This unbalanced
phono connector is used to
The Listen LA-201
connect an unbalanced high
power supply
impedance line or speaker
connects here.
input.
Shows which
channel is
Indicates RF
selected
output power (full,
½ or ¼) - select
on rear panel (see
below)
CONTOUR: Equalization adjust-
ment. Turn counter-clockwise for
voice and clockwise for music
Set switch to match your
INPUT 2 source. The level in
the LINE position is -10dBu
and in the SPEAKER posi-
tion, it is +10dBu.
Select MIC or LINE input here for
INPUT 1. Mic input level is -55dBu,
in the LINE position, the input level
is +4dBu.
If decimal is lit,
channel is locked
Plug in a head-
set and adjust
volume
CHANNEL SELECT
TO LOCK CHANNEL: press
UP and DOWN buttons
simultaneously and hold
for 5 seconds. Press both
and hold again to unlock.
INPUT 1: Used for balanced
connection of a microphone or
line level input. This combina-
tion connector accepts either
XLR or ¼" phone plugs.