Table of Contents
Advertisement
LT-800 Setup Instructions (cont.)
Set SQ™ (Super Quiet) and Process Features
5
Your transmitter is shipped to you with SQ (super quiet) enabled and Process disabled. For
a detailed description of these features and when to use them, please refer to page 12.
To Disable or Enable SQ and Process Features:
With the unit on press and hold the channel select "Down" button for 8 seconds. The
program (PGM) icon will appear on the LCD.
Once in the program mode,
the SQ and Process features can be turned on and off by pressing the channel select
buttons. Press the channel select "Up" button to toggle between Process On and Off.
Press the channel select "Down" button to toggle between SQ On and Off.
If the green LED is illuminated on the front panel,
that feature is enabled. Once you have enabled or
disabled the features as desired, let the transmitter
exit the program mode by waiting 5 seconds.
6
Set RF Power
Set the RF POWER switch on the back of the unit
to 1/4, 1/2, Full (Level is indicated on the LCD
display). The amount of transmitted RF power that
you will need depends on your application. If you
are operating multiple transmitters in the same
environment, it is best to set the transmitters
output power to its lowest level to reduce the
possibility of interference.
8
Program
icon
LED lit when
Process is enabled
LED lit when
SQ is enabled
Full
power
1/2
power
Back of LT-800 unit
1/4
power
- +
Advertisement
Table of Contents
