Operating Tips; Inspection And Maintenance; If A Fault In The Hydraulic System Occurs Or If It Is Not Possible To Start The Engine - Gianni Ferrari Turbo 1 User Manual

11 – OPERATING TIPS
WHEN USING THE MACHINE FOR THE FIRST TIME, ALWAYS BECOME FAMILIAR WITH
THE LOW SPEED CONTROLS OVER FLAT AND LEVEL GROUND.
ALWAYS IDENTIFY ANY STATIC OBSTRUCTIONS SUCH AS MANHOLES SPRINKLERS,
PROJECTORS OR LIGHTS, ETC. CLEARLY.
- Cut the lawn when the grass is not too wet and tall. Prevent the blades from striking against clods of earth
- If wet or tall grass must be cut, regulate the advancement speed and slow down
- Check the correct adjustment of the mower deck cutting height (see chapt. 13)
- Keep the blades sharp (see chapt. 15)
- At the start of each work session, check the operation of the grass distribution system within the rear grasscatcher as
indicated in Chapter 12.
- At the end of each work session, clean the lower part of the mower, the conveyor, the turbine, the distribution stack.
The internal parts of the machine should be cleaned with compressed air, avoiding water jets. Remember that grass, dust
and moisture are highly corrosive;
- If the machine becomes clogged during work, lift the mower deck, switch off the engine and free any clogged ducts
with an appropriate tool.
12 – INSPECTION AND MAINTENANCE
Note: the bodywork must be opened in order to carry out the
majority of the described inspections. Proceed in the following
way:
a) Dump the grasscatcher
b) Switch off the engine
c) Set the connecting tie of the elevator in the vertical position
d) Set the steering column in the vertical position
e) Free the bodywork locking hooks
f) Lift the bodywork
Proceed in the opposite way to close the bodywork
CHECKING OPERATIONS MUST BE EXECUTED BY EXPERT PERSONNEL. THE MACHINE
MUST BE PLACED ON A LEVELLED GROUND WITH PTO DISCONNETED AND PARKING
BRAKE INSERTED. THE ENGINE (WHERE IT IS NOT PRECISELY SPECIFIED) MUST BE
STOPPED AND THE KEY MUST BE REMOVED.
IF A FAULT IN THE HYDRAULIC SYSTEM OCCURS OR IF IT IS
NOT POSSIBLE TO START THE ENGINE:
Bring the lever to lift position (pull it backwards and keep this position by
means of a tool as shown in the side picture) while manually lifting the
grasscatcher.
©GF Gianni Ferrari 10-2001
Page . 16
Turbo 1 -2 - 4
Operator's Manual