TEC MA-1595-1 SERIES Owner's Manual page 214

5. PROGRAMMING OPERATIONS
NOTES: 1. Network Status Table
Code
0
1
2
3
4
5
6
7
8
In the above table, only Code 5 and Code 6 can be set.
Code 5: This code should be set before performing Default Gateway setting (6 [ST]).
Code 6: When this code is set, the Subnet Mask setting (5 [ST]) will be effective.
2. Self IP Address, IP Address of Master terminal, Subnet Mask, and Default Gateway are
programmed with 12-digit value (000..000 to 255..254), respectively.
Example) To program "192.168.0.250", enter 192168000250.
Initial setting values of the Self IP Address and the Default Gateway are as shown below.
Self IP Address:
Default Gateway:
3. Never assign the same In-line ID to terminals on the same In-line system.
Example) To assign Terminal ID No. 4 to the Terminal used as the Satellite Terminal of the in-line system:
In-line ID No.:
Network Status:
IP Address:
IP Address of Master Terminal:
Subnet Mask:
Default Gateway:
Key Operation: Mode Lock SET and IN-LINE Lamp illuminated,
enter 77, depress [@/FOR].
1 [ST] 04 [#]
2 [ST] 0 [#]
3 [ST] 192168000200 [#]
4 [ST] 192168000250 [#]
[AT/TL]
Item
No Status
Default Gateway
Subnet Mask auto-setting
When this code is reset, the Subnet Mask auto-setting will be performed as follows.
IP Address first section value
0 to 127
128 to 191
192 to 223
192.168.0.254
192.168.0.1
04
No Status
192.168.0.200
192.168.0.250
255.255.255.0 (Default)
192.168.0.1 (Default)
(In-line ID No.)
(Network Status)
(IP Address)
(Master IP Address)
(Complete this Submode)
5.2 Programming Operations Added for In-line Terminals
Set
Used
Ineffective
Subnet Mask
255. 0. 0.0
255.255. 0.0
255.255.255.0
5- 4
Reset
Not used
Effective
7(& 6725( 7(& 6725(
 3($&+ '5,9(
3+21( 
2SHQ  DP WR  SP
&ORVHG HYHU\ :HGQHVGD\
 681 
3
3


   
   
  70
EO1-11152