WARNING! Accessible parts of the hood may become hot when used with cooking appliance. INSTALLATION SPECIFICATIONS: Use only the fixing screws supplied with the product for installation. Use the correct length screws which are identified in the Installation guide. WARNING! Failure to install the screw or fixing device in accordance with these instructions may result in electrical hazards.
INSTALLATION - MONTAGEANLEITUNG Der Mindestabstand zwischen dem Kochfeld und der unteren Kante der Dunstabzugshaube muss bei Elektroplatten 50 cm und bei Gasherden oder kombinierten Herden 65 cm betragen. Schreiben die Installationsanweisungen des Gaskochfelds einen größeren Abstand vor, ist dieser natürlich zu beachten. Beauftragen Sie einen qualifizierten Techniker mit der Installation.
Fig. 1 Material supplied Remove all the components from the packets. Check that all the components are included. • Hood assembled with motor and lamps installed. • Flue support bracket • Assembly template • Filter/s • Instruction manual • 1 - adapter Torx T10 •...
SAFEGUARDING THE ENVIRONMENT 12. The appliance is not intended for use by children or persons with limited physical, sensory or mental abilities or without 1. Packing experience and knowledge of it, unless they are under the Packing materials are 100% recyclable and are marked with the supervision of or instructed in its use by a person responsible recycling symbol .Comply with the local regulations for...
Electrical connection AFTER-SALES SERVICE Before calling the After-Sales Service The mains voltage must match that given on the rating plate 1. Check to see if you can fix the problem yourself (see located inside the hood. If provided with a plug, connect the “Troubleshooting Guide”).
The hood is designed for use in “Extractor version” or in “Filter version”. Extractor Version Fumes are extracted and expelled to the outside through an exhaust pipe (not supplied) fixed to the hood exhaust pipe connector (Fig.d, Fig.e). Depending on the exhaust pipe purchased, provide for suitable fixing to the exhaust pipe connector. Important: If already installed, remove the carbon filter/s.
Active carbon filter (filter hoods only): The carbon filter must be cleaned once a month in a dishwasher at the highest temperature, using a normal dishwasher detergent. Wash the filters on their own. After washing, reactivate the carbon filter by drying it in the oven at 100°C for 10 minutes.