Makita LS1212 Instruction Manual page 29

Turn the hex bolt on the left side
I
of the arm two or three revolutions
counterclockwise. Turn the hex bolt
on the right side of the arm two or
three revolutions counterclockwise to
tilt the blade to the left.
Carefully square the side of the blade
with the top surface of the turn base
using the triangular rule, try-square,
etc. by turning the hex bolt on the
right side of the arm clockwise. Turn
the hex bolt on the left side of the arm
clockwise as far as it will go. Then
tighten the lever securely.
Make sure that the two pointers on
the arm point to each 0" on the bevel
scale
on
the arm holder. If they do not
point to O", loosen the screws which
secure the pointers and adjust them
so that they will point to 0".
I
Screws
Bevel scale
~
nter
29