Makita LS1212 Instruction Manual page 24

Crown molding stoppers (optional
molding without tilting the saw blade.
Install them on the turn base as shown
in the figure.
accessories) allow easier cuts of crown
Guide fence
Crown molding Crown molding
stopper
L
stopper
R
Crown molding stopper
Position in Fig ( C ) Miter angle
0
Right 4 5 '
Left
45"
Q
0
0
Right 45"
For inside corner
For outside corner
Fig.
(D)
Position crown molding with its WALL CONTACT EDGE against the guide fence and its
CEILING CONTACT EDGE against the crown molding stoppers as shown in Fig. (D).
Adjust the crown molding stoppers according to the size of the crown molding. Tighten
the screws to secure the crown molding stoppers. Refer to the table (C) for the miter
angle. Use the sub-fence R to secure the crown molding more firmly.
Finished piece
Save the right side of blade
Save the left side of blade
Save the right side of blade
Save the left side of blade
24