FingerTec Face ID2 Installation Manual

Installation Guide
Face ID2
Face & Fingerprint Recognition for
Time Attendane & Door Access Control System
w w w . f i n g e r t e c . c o m
Step 1
Determine the Location and Positioning
of the Installation
•
Avoid installing the terminals in locations that has contact with
a strong light source (e.g direct sunlight, spotlight, fluorescent
light, etc)
•
Avoid installing the terminals in locations with high moisture or
condensation levels in the air
•
The recommended installation height of the terminal from the
ground is 1.2 meter.
Step 2
Mounting of Terminals on A Wall
Back Plate
4 feet / 1.2 meter
(recommended)
•
After determining the height of the terminal from the ground
level and have made the relevant marks on the wall, drill the
screws into the wall to hang the back plate.
Refer to Appendix II for dimensions and measurements of instal-
lation.
INSTALLATION TIPS:
Best installation location of Face ID 2
must
1 - Avoid sunlight.
2 - 2 meters away from any light source i.e.
ceiling direct flourescent light
3 - Suggested 1.2m from the ground level
(measure from ground to the face captur-
ing camera)
Step 3
Wiring for Power Supply
1. Use the power adapter provided in the package and insert the
power adapter to the port marked A in the diagram.
2. Use power cables (black and red) to connect to a linear power
supply with specifications of 5VDC 3A (Marked B).
POWER SUPPLY (B)
GND
+12V
ALARM PORT
ACCESS
CONTROL
PORT
RS232/RS485 SERIAL PORT
1. RS485 Single Connection
485-
485+
485+
485-
GND
RS232/RS485
Data Converter
TXD
RS232
2. RS485 Network Connection
RXD
cable
485+
GND
485-
WD1
485+
3rd party controller
RS232/RS485
with 26 bits wiegand
WD2
4851
input
Door Lock connector. Refer to Appendix I
DC12V 3A
Power Supply
POWER
ADAPTER
PORT (A)
USB PORT
TCP/IP PORT
RX+
RX-
RX+
RX-
Data
Converter