Advertisement
Configuring with MyPBX
Configuring Digium IP phone with MyPBX
This guide is applicable to Digium D70/D50/D40.
Important:
This guide has been tested for Digium D70 with firmware version 1_0_0_44308. Be
aware that different firmware revisions may have different web interface formats
and functionality.
Register with MyPBX
1.
Digium D70 is a POE IP phone. Start up the phone and identify its IP Address –
press
Menu->Admin
Settings. In this guide, the IP of the IP phone is 192.168.5.232; the IP of MyPBX
is 192.168.5.138
2.
Point your browser to the web interface of the phone: http://192.168.5.232
3.
Enter the phone's login username (default "admin") and password (default
"789").
4.
Click on the "Lines" tab
5.
The differences between Line1 and other lines
In "Line1" tab, you can set the function of "Msgs" button; in other lines tab, you
should configure "Line status" before you register an extension. The status of
Line1 is "YES" by default.
Setting the function of "Msgs" button in line1 tab: you can enter the feature
code of voice mail or other extension's number. If you enter extension's number,
"Msgs" button can be used as a speed dial button; if you enter the feature code
of voice mail, pressing "Msgs" button will let you enter voice mail box, and this
www.yeastar.com
Settings->enter
Figure 1 Page after login
Figure 2 Setting the function of "Msgs" button
Digium IP Phone Configuration Guides
default
password:
789->Network
Page 2
Advertisement
