Pride Mobility Quantum 1103 Ultra Series Owner's Manual page 28

V . C O M F O R T
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a hex key.
See figure 20.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the setscrew.
2. Turn the setscrew to raise or lower the front of the foot
platform.
Anti-Tip Wheels
The anti-tip wheels are designed to give your power chair
increased stability on rough surfaces. The anti-tip wheels
are preset at the factory for smooth surfaces or indoor use
only. If you plan on using your power chair on rough sur-
faces, it may be necessary to adjust the anti-tip wheels to
better suit your needs. The anti-tip wheels may need ad-
justment if the following occurs:
! When coming to a stop, your power chair tips forward
excessively.
! The anti-tip wheels constantly rub the ground.
WARNING! Consult your Quantum Rehab
Specialist before attempting to change
the anti-tip wheel height! Changing the
anti-tip wheel height affects handling
under acceleration!
WARNING! The higher you raise the anti-
tip wheels, the more you increase your
power chair's tendency to tilt forward
w h i l e d e c e l e r a t i n g .
compensate for this by having your
Quantum Rehab Specialist make a small
adjustment to the pre-programmed
deceleration setting in the controller or
by moving the seat assembly farther to
the back of your power chair.
PROHIBITED! Do not remove the anti-
tip wheels.
NOTE: Each drive tire (pneumatic only) must be in-
flated to 35 psi (2.4 bar) and the user must also be
seated in the power chair in order to properly adjust
the anti-tip wheels.
To adjust the anti-tip wheels:
1. Loosen bolt A. See figure 21.
2. Remove bolt B.
3. Raise or lower the anti-tip wheel bracket. Each hole is
0.50 in. (1.27 cm) apart.
28
A D J U S T M E N T S
Figure 20. Bottom View of Foot Platform
Figure 21. Anti-Tip Wheel Assembly
Yo u c a n
www.quantumrehab.com
ANTI-TIP WHEEL
SETSCREW
A
B
Quantum 1103 Ultra Series