Pride Mobility Quantum 1103 Ultra Series Owner's Manual page 26

V . C O M F O R T
Controller Position
You can move the controller in toward or out away from
the armrest, or change the position of the controller for ei-
ther left-hand or right-hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the
seat frame or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See
figure 17.
3. Slide the controller into or out of the armrest to the
desired position.
4. Tighten the setscrew to secure the controller.
To change the controller position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the
rear shroud.
3. Unplug the controller connectors from the power pod.
4. Cut the wire ties that attach the controller cable to
the armrest.
5. Flip up the armrest so it is perpendicular to the floor.
6. Loosen the setscrew on the controller bracket. See
figure 17.
7. Slide the controller out of the armrest.
8. Loosen the setscrew in the other armrest.
9. Place the controller in the other armrest.
10. Tighten the setscrew in each armrest.
11. Route the controller connector to the back of the power
base and secure the controller cable to the armrest
receiver with wire ties.
12. Plug the controller connectors into the power pod. See
figure 7.
13. Reinstall the rear shroud and tighten the fasteners.
NOTE: If your power chair is equipped with a Syn-
ergy Seat or TRU-Balance Power Positioning System,
refer to the controller adjustment information provided
in separate manuals.
26
A D J U S T M E N T S
Figure 17. Underside of Armrest
www.quantumrehab.com
CONTROLLER BRACKET
SETSCREW
Quantum 1103 Ultra Series