Table of Contents
Advertisement
RedPlate RPHD100 Operations Guide
The RPHD100 comes complete with a 3 button footswitch and a footswitch cable. The cable used is a regular MIDI cable and is readily
available in any length at most music stores.
MidBoost – Girth Boost feature. This button increases the size of the treble capacitor for more upper midrange. The front panel MID
switch must be on (UP) for proper footswitch operation.
Overdrive – Character Boost feature. When lit, the Drive section of the amplifier is active, not lit, means the section is bypassed. The
footswitch button does not work when the rear panel Overdrive switch is in Manual position.
BOOST – Preamp Boost feature. The footswitch button does not have any affect when the rear panel Boost switch is in Manual position
1. Check the Standby switch to make sure it is toggled downward for Standby operation (the Standby switch is located next to the
Mains power switch on the rear panel.
2. Toggle the main power switch to the up position (this switch is located at the top of the IEC input module). The front panel pilot light
should be lit.
3. Wait one minute and then toggle the Standby switch upwards to the Operate position.
4. POWER OFF – Toggle the main power switch downward, there is no need to go into standby first although it will not hurt anything.
OTHER FEATURES
POWER ON/OFF PROCEDURE
5
Advertisement
Table of Contents
