Other Features - RedPlate Black-n-Blues Operation Manual

RedPlate Black-n-Blues Operations Guide
Impedance Selector Ω - Set this to the total impedance of all attached speakers.
SEND and RETURN Jacks – The send jack connects to the input of an external effects device
and the return jack connects to the output of an external effects device. The return jack interrupts
the signal path so the external effects unit must mix the wet and dry signals.
Footswitch Jack - This is a standard 180 degree 5 pin DIN jack for footswitch connection. If a
replacement cable is needed, make sure all 5 wires are supported. The pinout is conveniently
located on the rear panel for use with automated switcher conversion boxes.
SMOOTH Switch – Employs local negative feedback in the clean preamp for a hint of
compression.
Humbucker / Single coil Switch – Sets the amount of bass gain in the input of the clean
preamp stage, useful for matching the amplifier to the guitar type.
The Black-n-Blues comes complete with a footswitch and a 25' footswitch cable. The cable
used is a regular MIDI cable and is readily available in any length at most music stores.

OTHER FEATURES

STANDARD 3 BUTTON FOOTSWITCH
6