Using The Repetitive Cut Stop; Cleaning The Dust Bag - Performax 240-3690 Owner's Manual

USING THE REPETITIVE CUT STOP

The base extensions (1) have built-in stops for
use when making repetitive cuts of the same
length (Fig. 27). To use the stop, simply rotate
the stop (2) 90° so it provides a positive stop for
the workpiece.
NOTE: To adjust the length of the piece to be
cut, simply loosen the base extension locking
screw and slide the base extension in or out
until the cut stop is the correct distance from the
blade. The cut stop can be used for repetitive
cut lengths between 6" & 12".
Fig. 27
OPERATING THE MITER SAW

CLEANING THE DUST BAG

The dust collection bag located behind the
motor assembly must be cleaned regularly to
maintain its efficiency.
1. To remove the dust bag, squeeze the two
wire clamp wings (1) together and slide the
dust bag off the dust chute
(Fig. 28).
2. Hold the open end of the dust bag over a
trash can and shake all the sawdust from
the bag.
3. Reinstall the dust bag on the dust chute by
reversing the removal instructions in
paragraph #1 above.
23
Fig. 28