Adjusting The 0° Bevel Angle - Performax 240-3690 Owner's Manual

ADJUSTING THE 0° MITER ANGLE – cont'd
ADJUSTING THE 0° BEVEL ANGLE
1. Lift the bevel angle locking lever (1)
upward and rotate it clockwise to allow the
cutting head (2) to rotate (Fig. 10).
2. Lift the 0° bevel stop (3) to the vertical
position (Fig. 11).
3. Rotate the cutting head clockwise until the
0° adjustment screw (4) contacts the left
hand side of the 0° bevel stop (5).
4. Rotate the bevel angle locking lever
counter clockwise to lock the cutting head
in the 0° position.
ADJUSTING THE MITER SAW
Fig. 9
Fig. 10
5. Lock the handle in the down position. Hold
a combination square (not provided) (6)
against the base (7) and beside the saw
blade (8) (Fig. 12).
NOTE: Make sure the square rests against
the body of the blade without touching the
carbide tips or teeth. When properly
positioned, the full length of the
combination square should contact both
the saw blade and the base. If the saw
blade does not contact the full length of the
combination square, adjust the bevel angle
as follows:
6. Lift the cutting head to its maximum height.
7. Make sure the cutting head 0° adjustment
screw is contacting the left hand side of the
0° bevel stop.
16
Fig. 11
Fig. 12