Martin p Xciter User Manual page 52

Patch
4. As explained in the introduction, you can patch two sets of values to the button: ON values and OFF values.
The ON values appear when the DA button is pressed; the OFF values appear when it is released. When
you enter the patch, the ON values are shown by default. Press {ON values} or {OFF values} to swap
between the display of ON
5. Use the bump button under the DMX address to add/remove the physical channel to/from the patch. By
default, the ON value of a channel is 255 and the OFF value is 0. Example: Add channels 501 and 502.
Use the faders to change values. To fine-tune a value, you can hold the bump button while you turn the
centre top scroll wheel.
6. There are two operating modes for the DA button: toggle and flash. The default mode is flash.
When the button is in flash mode, the ON values appear as long as you hold the DA button. The OFF
values appear when you release the DA button. When the button is in toggle mode you can swap between
the ON and OFF values each time you press the DA button. Press {Toggle} or {Flash} to change the mode.
7. Press [ESC] to return to the DA patch menu.
8. You can choose to patch another DA button now. The procedure is the same for all DA buttons.
Or press [ESC] again to return to the patch menu. Upon [ESC] Xciter asks whether you want to store the
changes to the patch table if you have made any. Press {Yes} to store and exit or {No} to exit without
storing.
52
and OFF values.
Xciter user manual