Martin p Xciter User Manual page 36

Fixture library
9. The Lamp on, Lamp off and Reset procedures are programmed in the same way. We will use Lamp on as
an example.
10. Press the softkey next to the procedure you wish to create.
11. Press [LOAD] to create a procedure in case there is none.
Xciter adds the first step automatically.
If you are editing a fixture definition, you can also press [EDIT] if you want to modify an existing procedure
or press [CLEAR] to delete it. Xciter asks for confirmation. Press {Yes} to confirm, {No} to cancel.
a. Use the faders to adjust the internal control channels in the current step.
Use the top center jog wheel to scroll through the channels in case there are more than 6.
To fine-tune a value, you can hold the bump button of the corresponding channel while you turn
the top center jog wheel.
b. Press {Step time} to adjust the duration of the step followed by [ENT] to confirm or [ESC] to leave
unchanged.
c. Press [LOAD] if you want to add another step to the procedure.
d. Repeat steps 9a-9c until you have programmed the complete procedure.
e. Press [ESC] to go back to the advanced configuration menu.
12. Press {Shut close} to adjust the shutter close value.
Use the top right jog wheel or arrow keys to modify the value.
Use [CLEAR] and general-purpose keys 1-10 to input a new value.
Press [ENT] to confirm, [ESC] to leave unchanged.
36 Xciter user manual