Martin p Xciter User Manual page 15

7. When setup has finished copying all the necessary files, it will display the following message. If you had a
previous installation, make sure there is no Xciter connected to the PC at this point.
8. Finally, press Finish to exit the setup wizard.
9. Power the Xciter on. Wait until it has completed booting and shows the intro screen. This normally takes a
few seconds.
Note: If a previous upgrade has failed, the displays may remain dark. However, even if this happens, you
should still be able to perform a new upgrade.
10. Use the USB cable to attach the Xciter to the PC.
Warning: Only use the USB-B connector (center-top of the front panel) on the Xciter to connect to the PC.
The USB-A connector (top-right corner of the front panel) only serves to supply 5V power to a USB desk
light.
11. The operating system will automatically detect the Xciter and the hardware wizard will appear. If the wizard
asks to connect to Windows® Update to search for software, select 'No, not this time' and press next.
Xciter user manual
Installation
15