Recording; Selecting Input - Pioneer PRV-LX1 Operating Instructions Manual

Recording

The recording function involves inputting video/audio
signals from a VTR or other similar video playback
device ("external VTR"), converting those signals to
data compatible with the DVD video format and
recording the data to the HDD or to disc. The data
from the hard drive is then recorded to a DVD-R/RW
disc. A playback video/audio signal is simultaneously
output. If the SET UP section [Operation] = [Video
Settings] > [Composite OUT] is set to "Source
Monitor", the input image will be passed through
during recording as well (see page 31). In addition,
in the event this command is set to "Decoder Out",
the output signal will be the encoded/decoded
version of the original input video/audio signal.
Note 1:
The playback video signal is delayed about 4 seconds
with respect to the input signal due to the time
required for encoding and decoding.
Note 2:
Recording will not begin if a copy-guard protected
input signal is detected.
Note 3:
When set to "Source Monitor" (pass-through
output), the output will switch to "Decoder Out" if
the OSD is turned on.
32
PRV-LX1
En

Selecting Input

On the Function Menu, the STATUS section = [V
Input] and [A Input] commands indicate the
currently selected video and audio input signals. Use
the CURSOR and ENTER buttons to change to the
connectors for different input signals if desired. Also,
when "DV" is designated for [V Input] or [A Input],
both [V Input] and [A Input] are set to "DV".
STATUS section = [V Input]
STATUS section = [A Input]
Drive indicators