Adjusting The Brightness Of The Fluorescent Display - Sherwood TX-5505iD Operating Instructions Manual

TX-5505iD(G)_ENG_101110_TX-5505iD(G)_ENG 2010-11-10 오전 9:31 페이지 24
■When selecting "Set Time/Date"
• You can set the various time settings.
Set Time/Date menu
Set Format
Set Timezone
• The main menu will be displayed in 8 seconds.
① While displaying the Set Time/Date menu mode, select
the desired item, then confirm your selection.
TUNING / PRESET
TUNING / PRESET
• Each time the TUNNING/PRESET knob is rotated or the
CURSOR UP(▲)/DOWN(▼) buttons are pressed, the
item is selected as follows :
＊Set Format : When selecting 12 Hour or 24 Hour format.
＊Set Timezone : When selecting the timezone depending
on where you are using this unit.
＊Daylight Saving : When turning the Daylight Saving
② While displaying the item menu, perform the above step
① to set as desired.
• Then the selected item is marked with
■When selecting "Factory Reset"
• You can reset the network settings, time/date settings and
stations added to "Station List" to the factory default
except the stations added to "My Favourites" and "My
Added Stations".
Press enter
to confirm reset
• Press the ENTER button to select.
or
function on or off.
.
■When selecting "Software Update"
• From time to time we will make software updates
available for this unit. These are necessary for general
maintenance reasons, as well as for adding additional
functionality to your unit. Software updates are carried out
over-the-air, via broadband connection.
Checking for
new version - - -
• If an update is available, confirm to the instructions to
commence the download.
■Note :
• Do not disconnect the AC input cord or turn the power off
during a software update. Should this happen, it may be
result in malfunction or cause damage to this unit.
■When selecting "Information"
• You can check the software version and the radio ID
number.
Information menu
SW Version
Radio ID
• The previous status will be displayed in 8 seconds.
• While displaying the menu, select the desired item to be
checked, then confirm your selection.
TUNING / PRESET
TUNING / PRESET
• Then the selected information is displayed.
ADJUSTING THE BRIGHTNESS OF
THE FLUORESCENT DISPLAY
DIMMER
or
• Each time the DIMMER button is pressed, the brightness
of the fluorescent display changes as follows :
→ ON → dimmer → OFF
• In the display OFF mode, pressing any button will cancel
the display OFF mode for several seconds to display the
operation status.
24
or