Sherwood TX-5505iD Operating Instructions Manual page 11

TX-5505iD(G)_ENG_101110_TX-5505iD(G)_ENG 2010-11-10 오전 9:30 페이지 11
Manual tuning
• Manual tuning is useful when you already know the
frequency of the desired station.
• After selecting the desired band (and the tuning mode in
case of using the TUNING/PRESET knob), rotate this
knob one by one slowly or press the TUNING UP(+)/
DOWN(-) buttons repeatedly until the right frequency has
been reached.
TUNING / PRESET
• Press and hold down the TUNING UP(+)/DOWN(-)
buttons to reach quickly the right frequency.
Auto presetting
• Auto presetting function automatically searches for FM
stations only and stores them in the memory.
1.
While listening to FM broadcasts, press the
AUTO PRESET button.
AUTO PRESET
or
BACK
• Then "FM AUTO PRESET" flickers for several seconds.
• If "FM AUTO PRESET"goes off, press the AUTO
PRESET button again.
2.
When "FM AUTO PRESET" flickers, press the
AUTO PRESET button again.
• Then "SEARCH" flickers and the tuner starts auto
presetting.
• To stop auto presetting, press this button again.
• Up to 40 FM stations can be stored.
■Notes :
• FM stations of weak strength cannot be memorized.
• To memorize AM stations or weak stations, perform
"Manual presetting" procedure with using "Manual tuning"
operation.
or
Manual presetting
• You can store up to 40 preferred stations in the memory.
1.
Tune in the desired station with auto or manual
tuning.
2.
Press the TUNING/PRESET knob or the
MEMORY button.
TUNING / PRESET
or
F M S T
8 9 . 1 0
• The preset number flickers for several seconds.
■On the front panel
3.
Rotate the TUNING/PRESET knob to select the
desired preset number(1~40) and press this
knob.
TUNING / PRESET
• The station has now been stored in the memory.
• A stored frequency is erased from the memory by storing
another frequency in its place.
• If the preset number does not flicker or disappears, start
again from the above step 2.
4.
Repeat the above steps 1 to 3 to memorize
other stations.
11
M Hz P 0 2
TUNING / PRESET