Sherwood TX-5505iD Operating Instructions Manual page 12

TX-5505iD(G)_ENG_101110_TX-5505iD(G)_ENG 2010-11-10 오전 9:30 페이지 12
Continued
■On the remote control
3.
Select the desired preset number(1~40) and
press the ENTER button.
or
• When using the NUMERIC buttons
Examples:
within 10 seconds
For "3" :
within 10 seconds
For "21" :
within 10 seconds
For "40" :
F M S T
8 9 . 1 0
• Then it enters the name entry mode (that allows you to
give a name to the station) and the first digit flickers for
several seconds.
• Up to 8 characters can be entered for each name.
• If you do not give a name, perform the step 7, but ignore
the steps 4 ~6.
4.
Press the CURSOR LEFT(◀)/RIGHT(▶)
buttons to select the desired digit.
• Then the selected digit flickers.
within 10 seconds
within 10 seconds
within 10 seconds
M Hz P 0 2
5.
Press the CURSOR UP(▲)/DOWN(▼) buttons
to enter the desired character on the flickering
digit.
• You can enter the desired among blank, A~Z, 0~9, ^, ', (,
), , +, ,, -, ., /, =.
6.
Repeat the above steps 4 and 5 to enter the
desired characters on the rest of the digits.
7.
Confirm your entry.
• The station and its name have now been stored in the
memory.
• A stored frequency and its name are erased from the
memory by storing new ones in its place.
• If the preset number does not flicker, disappears or the
digit does not flicker, start again from the above step 2.
8.
Repeat the above steps 1 and 7 to memorize
other stations.
12