Operations; Listening To Radio Broadcasts - Sherwood TX-5505iD Operating Instructions Manual

TX-5505iD(G)_ENG_101110_TX-5505iD(G)_ENG 2010-11-10 오전 9:30 페이지 10

Operations

LISTENING TO RADIO BROADCASTS

Before operation
• Turn the power on.
ON/ STANDBY
or
• Each time the POWER ON/STANDBY button on the front
panel is pressed, the tuner is turned on to enter the
operating mode or off to enter the standby mode.
• When it is in the standby mode, the STANDBY indicator
lights up. This means that the tuner is not disconnected
from the AC mains and a small amount of current is
retained to support the operation readiness.
• On the remote control, press the POWER ON button to
enter the operating mode or press the STANDBY button
to enter the standby mode.
Auto tuning
or
Band FM mode
F M S T
8 7 . 5 0 Hz
Frequency
• Each time the BAND button on the front panel is pressed,
the band and the FM mode change as follows :
→FM STereo → FM MONO→ AM → digital broadcast
(STEREO (STEREO indicator
indicator lights up) goes off)
M P0 1
Preset No.
Tuning/
Preset mode
• Each time the BAND button on the remote control, the
band changes as follows :
→ FM → AM → digital broadcast
• For details on FM mode, see "Listening to FM stereo
broadcasts" on page 13.
• To listen to Internet Radio broadcasts, DAB/DAB+
braodcasts, etc., select digital broadcast. (For details, see
"LISTENING TO INTERNET RADIO BROADCASTS,
DAB/DAB+ BROADCASTS" on page 16.)
■On the front panel
2.
Press the TUNING/PRESET MODE button to
select the tuning mode, then rotate the TUNING
/PRESET knob over several steps once.
T/ P MODE
MENU
• Each time the TUNING/PRESET MODE button is pressed,
the mode changes as follows :
Tuning mode ↔ Preset mode
("P" goes off) ("P" lights up)
■On the remote control
2.
Press the AUTO TUNING button.
• "AUTO" is displayed and the tuner will now search until a
station of sufficient strength has been found. The display shows
the tuned frequency and the TUNED indicator lights up.
• During auto tuning, press the TUNING UP(+)/DOWN(-) buttons
to change the received frequency to a higher frequency or a
lower frequency.
• If the station found is not the desired one, simply repeat this
operation.
• Weak stations are skipped during auto tuning.
10
TUNING / PRESET