Advertisement
Press the BACK button to exit the naming page and return to the BUS 1 SETUP
display.
BUS TYPE
Scroll down to the Bus Type line. In default state this should read 'Aux Bus'
Press the ADJUST button and you can now change between 'Aux Bus' and 'Group
Bus' . Press the ADJUST button to confirm your selection.
You will notice that the faders change colour to indicate the selection you have
made.
Note! From this page you may select the 'PRE' fade send to be PRE or
POST EQ.
STEREO LINKING
Any Odd/Even numbered pair of buses can be linked with the exception of the 4
Lexicon buses which are always mono. Scroll down to the Bus Width line. In default
state this should read 'Mono'. Press the ADJUST button and you can now change
between 'Mono' and 'Stereo', then press the ADJUST button to confirm your selec-
tion. You will now notice that the faders are linked for stereo operation.
Note! In this scenario one fader acts as the master and the other as the
slave. If you try to move both faders together you will feel resistance.
Use a single member of the linked pair to make level adjustments.
Soundcraft® Si Series Quick Start Guide Issue 1010
Page 19
Advertisement
