1
Setting Up and Using the Scanner
Quick Reference
Use this Quick Reference Guide (QRG) to find easy connection, scanning, and troubleshooting
instructions. For more details, including programming information, refer to the Programming Guide
(PG), which is available for download, viewing, and printing in English only from the HP website
http://www.hp.com/support.
Installation
Connect the interface cable to the rear of the scanner and to a USB connector on the host computer.
Verify operation by scanning known-good barcodes. The unit should beep and/or flash its good read
LED and send the barcode data to the host computer. If not, refer to
The HP Presentation Scanner utilizes illumix™ intelligent illumination technology to optimize light
levels for a variety of barcode scanner functions including automatic reading of barcodes from printed
surfaces, mobile devices and image capture in variable contrast environments.
Mounting the Scanner (Optional)
The scanner can be permanently attached to a wall or counter top as described below.
1.
After identifying an optimal position for the scanner, cut out and securely hold the screw hole
template in the desired position matching the scanner's footprint.
2.
Mark the center of both screw locations using a pencil or marker and remove the template.
ENWW
Troubleshooting on page
Quick Reference
4.
1