Obtaining Dpatch Data - Kodak DryView 8150 Service Manual

Service Manual
a. Uncheck the "Current" box.
b. Select the Lot Number of the film from the "Select Lot#" dropdown menu.

7-2-10. Obtaining Dpatch Data

This procedure obtains the density of the Dpatch from the last film calibration, if the film contained a
Dpatch.
1. From the main menu of the SERVICE TOOL, select Diagnostics>MIS>Dpatch.
2. Click [Run].
3. Check Status ("Pass" or "Fail") and the Summary.
Note
The Summary will include the Density of the Dpatch and the ATTENUATOR setting that achieved
this density value. Dpatch density must be between 0.7 and 1.3. The values are zero in the above
example because the film did not use a Dpatch.
7-20
7F3318 2005 July Rev. B