Cisco DPC3928 DOCSIS User Manual page 42

Chapter 2 Installing the D OC SIS Wireless Residential Voice Gateway
5 Locate the AC power cord provided with your residential gateway. Insert one
end of the power cord into the AC connector on the back of the residential
gateway. Then, plug the AC power cord into an AC outlet to power-up the
residential gateway. The residential gateway will perform an automatic search to
locate and sign on to the broadband data network. This process may take up to 2-
5 minutes. The residential gateway will be ready for use when the POWER, DS,
US and ONLINE LEDs on the front panel of the residential gateway stop
blinking and remain on continuously.
Plug in and power on your PC and other home network devices. The LINK LED
6
on the residential gateway corresponding to the connected devices should be on
or blinking.
7 Once your residential gateway is online, most Internet devices will have
immediate Internet access.
Note: If your PC does not have Internet access, refer to How Do I Configure
TCP/IP Protocol? (on page 32) for information on how to configure your PC for
TCP/IP. For Internet devices other than PCs, refer to the DHCP or IP Address
configuration section of the User Guide or Operations Manual for those devices.
20 OL-29161-01