Cisco DPC3928 DOCSIS User Manual page 27

WIRELESS ON/OFF (Optional)—Press this button to activate and turn on the
7
Wireless feature. This feature allows users to transfer data over the wireless
connection. When the WIRELESS indicator is ON, it indicates that the Wireless
Access Point is operational. BLINKING indicates that data is being transferred
over the wireless connection. OFF indicates that the Wireless feature has been
disabled.
8 WIRELESS SETUP—Press this button to activate the Wireless Setup feature.
This feature allows users to add new Wireless Protected Setup (WPS) compliant
wireless clients to the home network. When the SETUP indicator is OFF (normal
condition), it indicates that the wireless setup is not active. BLINKING indicates
the user has activated wireless setup to add new wireless clients on the wireless
network.
TEL1—ON indicates telephony service is enabled. Blinks when line 1 is in use.
9
OFF indicates that phone service for TEL 1 is not enabled
10 TEL2—ON indicates telephony service is enabled. Blinks when line 2 is in use.
OFF indicates that phone service for TEL 2 is not enabled
11 BATTERY (optional model only)—ON indicates the battery is charged. Blinking
indicates the battery charge is low. OFF indicates the unit is operating from
battery power, the battery charge is depleted, or the battery is defective or
missing
Notes:
After the residential gateway is successfully registered on the network, the

POWER, DS, US, and ONLINE LEDs illuminate continuously to indicate that the
residential gateway is active and fully operational.
The high-speed data operation is disabled when operating on battery power;

only the telephone service (if available on this model) is active when operating
on battery power.
LEDs may behave differently when the residential gateway is running on battery

power (without AC power). Most LEDs are disabled if the unit is operating on
battery power. In this mode, the POWER LED blinks to indicate that the unit is
operating under battery power.
The residential gateway should only run on battery power when AC power has

failed. If the POWER LED indicates that the unit is running on battery power,
but the AC power has not failed, verify that the power cord is plugged into a
working AC outlet.
OL-29 161 -01
Front Panel Description
5