Cisco Small Business 200 Series Administration Manual page 40

Administration: File Management
Upgrade/Backup Firmware/Language
• Backup—Specifies that a copy of the file type is to be saved to a file on another device.
Enter the following fields:
• File Type—Select the destination file type. Only valid file types are shown. (File types are described
in the Files and File Types
• TFTP Server Definition—Select whether to specify the TFTP server By IP address or By name.
• IP Version—Select whether an IPv4 or an IPv6 address is used.
• IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The options are:
- Link Local—The IPv6 address uniquely identifies hosts on a single network link. A link local
address has a prefix of FE80, is not routable, and can be used for communication only on the local
network. Only one link local address is supported. If a link local address exists on the interface, this
entry replaces the address in the configuration.
- Global—The IPv6 address is a global Unicast IPV6 type that is visible and reachable from other
networks.
• Link Local Interface—Select the link local interface (if IPv6 is used) from the list.
• TFTP Server IP Address/Name—Enter the IP address or the name of the TFTP server.
• (For Upgrade) Source File Name—Enter the name of the source file.
• (For Backup) Destination File Name—Enter the name of the backup file.
STEP 4
• File Type—Select one of the following file types:
- Firmware Image—Select this to upgrade the firmware image.
- Language File—Select this to upgrade the language file.
• File Name—Click Browse to select a file or enter the path and source file name to be used in the
transfer.
STEP 5
• Remote SSH Server Authentication—To enable SSH server authentication (which is disabled by
default), click Edit. This takes you to the
and return to this page. Use the
authentication method (password or public/private key), set a username and password on the device
(if the password method is selected), and generate an RSA or DSA key if required.
Cisco Small Business 200 Series Smart Switch Administration Guide
section).
If you selected via HTTP/HTTPS, you can only select the Save Action: Upgrade.
Enter the parameters as described in this step.
If you selected via SCP (Over SSH), see
instructions. Then, enter the following fields: (only unique fields are described, for
non-unique fields, see the descriptions above)
SSH Server Authentication
SSH Server Authentication
SSH Client Authentication
page to configure the SSH server,
page to select an SSH user
5
for
39