Advertisement
Optional 6" or 12" extensions are available
for larger openings. Only one extension
recommended per gate.
If using gate on a stairway, it must be placed
either on top stair or on lowest stair at
bottom.
Push spindles A, B, C into three corners of
gate. Note these spindles are pulled not
screwed, into and out of their housings and
occasionally may be tight.
Center gate in opening, with bottom rail
resting on floor. Gaps on each side
should be equal.
Insert step plate under bottom rail on
desired side.
Release locking mechanism by pressing
locking button in while lifting handle.
BUTTON MUST ALWAYS BE PRESSED IN
WHEN LIFTING HANDLE. FAILURE TO DO
SO WILL RESULT IN HANDLE MECHANISM
BREAKING.
Pull out spindles A and B until they touch
mounting surface. With walk-through door
slightly open, tighten nuts toward gate
frame as tightly as possible using wrench
provided.
Each
spindle
and may be extended to varying lengths to
allow for molding, uneven walls, etc.
Spindles may be extended a minimum of 1"
but not more than 3 1/4" each side.
adjusts
individually
Advertisement
