Operating Instructions - Bosch 1364 Operating/Safety Instructions Manual

BM 1609929C59 06-10 :BM 1609929C59 06/10 6/24/10 8:10 AM Page 9
To prevent serious personal
W RNING
injury, always disconnect the
plug from power source before changing
wheels, or making any adjustments.
INSTALLING ABRASIVE WHEELS
Always use the arbor nut that has same
thread size as spindle.
1. Install inner flange onto spindle, with
recess in back side of flange engaging
matching area on spindle.
2. Install abrasive wheel onto spindle.
Always use wheel guard,
W RNING
foot plate and auxiliary
handle with this abrasive cut off machine.
PADDLE SWITCH
WITH "LOCK-OFF" FEATURE
The Paddle Switch enables the operator to
control switch functions of "Lock-OFF", and
"ON/OFF".
TO UNLOCK SWITCH AND TURN TOOL
"ON": Push the paddle lever FORWARD
(toward the spindle) then squeeze the paddle
lever.
TO SWITCH TOOL "OFF": Release pressure
on the paddle lever. The switch is spring
loaded and will return to "OFF" position
automatically.
SIDE HANDLE
The side handle, used to guide and balance
the tool can be bolted to either side of the
spindle housing depending on personal
preference and comfort. Always use the side
handle for maximum control and ease of
operation.
ADJUSTING DEPTH OF CUT
Loosen wing nuts, raise or lower foot plate to
desired depth, and securely tighten wing nuts
by hand.
To
W RNING
damage to the tool, always
adjust the foot plate to a depth of so the inner
or outer flanges never contacts the
workpiece surface.
Assembly

Operating Instructions

prevent recoil and
3. Install outer flange with flat side out.
4. Thread arbor nut provided onto spindle
finger tight, depress spindle lock and tighten
wheel with the wrench provided.
Do not overtighten. Cracks in
W RNING
the wheel can occur if
overtightened.
Do not depress spindle lock
C UTION
while the tool is running.
1
WING
NUT
-9-
0
P DDLE
SWITCH
WING
FOOT
NUT
PL TE